Business Community > All Threads > Multiple Public IPs Using PPPoE WAN Connection?
< All Threads

Multiple Public IPs Using PPPoE WAN Connection?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Multiple Public IPs Using PPPoE WAN Connection?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Multiple Public IPs Using PPPoE WAN Connection?
Multiple Public IPs Using PPPoE WAN Connection?
2020-12-24 13:40:36 - last edited 2021-04-18 10:26:14
Model: TL-R600VPN  
Hardware Version: V4
Firmware Version: 4.0.4 Build 20200313 Rel.41831

Is it possible to use more than one public IP using a PPPoE type WAN connection? It looks like I have to be using a static IP connection type for the WAN connection in order to config a One-To-One NAT for the other IP addresses. If this is correct, is it possible that it could work in the future with updated firmware?

  0      
 
  0      
 
#1
Options
3 Reply
Re:Multiple Public IPs Using PPPoE WAN Connection?
2020-12-25 09:17:50 - last edited 2021-04-18 10:26:14

@urbnsr normally with pppoe your IP will change after a period of time, you can not assign an unstable IP to an internal device. Unless you will have stable IP with pppoe? 

  0  
  0  
#2
Options
Re:Multiple Public IPs Using PPPoE WAN Connection?
2020-12-25 09:27:58 - last edited 2021-04-18 10:26:14

Dear @urbnsr,

 

It looks like I have to be using a static IP connection type for the WAN connection in order to config a One-To-One NAT for the other IP addresses. If this is correct, is it possible that it could work in the future with updated firmware?

 

Correct. The connection type needs to be static IP. There is no plan to change this for the time being.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#3
Options
Re:Multiple Public IPs Using PPPoE WAN Connection?
2020-12-25 12:19:14 - last edited 2021-04-18 10:26:14

Thanks for the replies and information. We do, in fact, have a static IP block. Since there are no plans to allow multiple IPs, I will cancel all but one static IP. Kind of wish I knew this ahead of time, but I can't check every detail.

 

  Thanks again.

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 1325

Replies: 3

Related Articles
Struggling to get multiple public WAN IPs working
627 0
PPPoE and Public IPs
940 0
Multiple Virtual Servers (port forwarding) to multiple public IPs
1393 0
ER8411 WAN IP Alias - Multiple WAN IPs - Same Port Forwarding
642 0
WAN goes down when using PPPOE
896 0
WAN Alias on pppoe WAN Connection
151 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.