Print and web based interface data no transferring through access point
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello, I have setup a new access point in my house to obtain better WiFi signal in my upstairs. I have it hardwired to my Local area network and configure it to a static IP address on my LAN's gateway. Also gave and enabled the 2.4/5 wireless radios SSID names appropriate to where it's located. Internet access works great signal is strong, but when I am connected to the new EAP225 with my laptop, I can not get the print Data to the printer. The printer is also hard wired off the same network switch the EAP225 is connected to. I have also found that I can not connect to the web based interface of The eap225 or any of my other network switches, yard access points, ventilation controllers, Data loggers, while connected to the EAP225's WiFi. I can only access them, and print when I get back onto the Hardwired side of the EAP225 or any of my other WiFi access points. Does anyone have any suggestions as to why and what I can do to get data to go through at the network level.
