Omada SDN 5.0.3 batch config BUG
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
my AP have already config Channel.
When use batch config change radio TX Power and keep channel Exiting . All AP in Batch Config change to same Channel.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Dear @Rewjang,
Rewjang wrote
my AP have already config Channel.
When use batch config change radio TX Power and keep channel Exiting . All AP in Batch Config change to same Channel.
Thank you for your valued feedback!
This issue has been reported to the R&D team for further investigation.
Update:
The R&D team has located the problem and will fix it in the subsequent Controller v5.1.7.
Once the new firmware is available, I'll update this post, welcome to subscribe!
- Copy Link
- Report Inappropriate Content
Dear @Rewjang,
Rewjang wrote
my AP have already config Channel.
When use batch config change radio TX Power and keep channel Exiting . All AP in Batch Config change to same Channel.
Thank you for your valued feedback!
This issue has been reported to the R&D team for further investigation.
Update:
The R&D team has located the problem and will fix it in the subsequent Controller v5.1.7.
Once the new firmware is available, I'll update this post, welcome to subscribe!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 757
Replies: 1
Voters 0
No one has voted for it yet.