SG2008 Not restricting admin access to port.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

SG2008 Not restricting admin access to port.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
SG2008 Not restricting admin access to port.
SG2008 Not restricting admin access to port.
2022-07-06 21:02:11
Tags: #Access-Control
Model: TL-SG2008  
Hardware Version: V3
Firmware Version: 3.0.2 Build 20210806 Rel.55686

Hi,

 

I am perhaps misunderstanding how this feature works, but I currently have set the Global Config > Access Control to enabled (within the standalone web-panel; not using controller) and set to `port-based` with only one line in the `Entry Config` table; setting port 1/0/1 to `snmp, telnet,http,https` access.

 

Despite this I can freely login to the web panel via https (I have http disabled) on a machine plugged into port 1/0/5.

 

From the manual:

 

Port-based: Only the users who are connected to certain ports can access the switch via the specified interfaces.

 

Is access control not working, have I misunderstood how it works, or is it dependent or related on other settings that need to be changed?

 

Thanks in advance for any help you can give me!!

  0      
  0      
#1
Options
1 Reply
Re:SG2008 Not restricting admin access to port.
2022-07-07 09:11:01

Dear @JollyAnonymous ,

 

JollyAnonymous wrote

Hi,

 

I am perhaps misunderstanding how this feature works, but I currently have set the Global Config > Access Control to enabled (within the standalone web-panel; not using controller) and set to `port-based` with only one line in the `Entry Config` table; setting port 1/0/1 to `snmp, telnet,http,https` access.

 

Despite this I can freely login to the web panel via https (I have http disabled) on a machine plugged into port 1/0/5.

 

From the manual:

 

Port-based: Only the users who are connected to certain ports can access the switch via the specified interfaces.

 

Is access control not working, have I misunderstood how it works, or is it dependent or related on other settings that need to be changed?

 

Thanks in advance for any help you can give me!!

 

Thank you so much for taking the time to report the issue to our community!

 

To better assist you, I've created a support ticket via your registered email address, and escalated it to our support engineer to look into the issue. 

 

The ticket ID is TKID220706998, please check your email box and ensure the support email is well received. Thanks!

 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 525

Replies: 1

Tags

Access-Control
Related Articles