Remote Access point failed to upgrade after updating Omada controller to Version:5.4.6

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Remote Access point failed to upgrade after updating Omada controller to Version:5.4.6

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Remote Access point failed to upgrade after updating Omada controller to Version:5.4.6
Remote Access point failed to upgrade after updating Omada controller to Version:5.4.6
2022-08-04 06:19:10 - last edited 2022-08-05 05:29:21
Hardware Version: V5
Firmware Version: 5.4.6

After updating controller(Version:5.4.6) Remote Access point failed to upgrade. May I Know if anybody has same issue or only this issue for me.

 

Current opened ports - TCP & UDP 29810 to 29814

 

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Remote Access point failed to upgrade after updating Omada controller to Version:5.4.6-Solution
2022-08-05 02:01:14 - last edited 2022-08-05 05:29:21

Dear @127.0.0.2,

 

Please ensure the “HTTPS Port for Controller Management” is opened.

 

Along with the full upgrade of SDN5 (Omada Controller is v5 and the Devices firmware is adapted to Controller v5), the Port used for device upgrading is up to the setting of “HTTPS Port for Controller Management”, which is TCP 8043 by default, you can go to Settings -> Controller -> Access Config to have a check.

 

For more details, you may check the post below.

 Solution  Failed to update Omada devices by Omada Controller Online

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  3  
  3  
#2
Options
1 Reply
Re:Remote Access point failed to upgrade after updating Omada controller to Version:5.4.6-Solution
2022-08-05 02:01:14 - last edited 2022-08-05 05:29:21

Dear @127.0.0.2,

 

Please ensure the “HTTPS Port for Controller Management” is opened.

 

Along with the full upgrade of SDN5 (Omada Controller is v5 and the Devices firmware is adapted to Controller v5), the Port used for device upgrading is up to the setting of “HTTPS Port for Controller Management”, which is TCP 8043 by default, you can go to Settings -> Controller -> Access Config to have a check.

 

For more details, you may check the post below.

 Solution  Failed to update Omada devices by Omada Controller Online

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  3  
  3  
#2
Options

Information

Helpful: 0

Views: 679

Replies: 1

Related Articles