Omada Network Map Not Mapping EAP235 Properly
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada Network Map Not Mapping EAP235 Properly
Tags:
#Adoption
I'm running the Omada Software Controller on a Synology DS920+ that's hardwired to the EAP235-Wall mentioned. The Office AP is then wired to port 2 of the TL-SG2008P. The software controller isn't mapping the Office AP properly. The Living Room AP is showing in the right location but the Office AP doesn't list an Uplink device.
Is there any way to resolve this and get the AP mapped properly as it's also not showing any clients underneath it and I think it's causing the WLAN AI to fail to properly run as well.