This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
After this latest update some ports which are supplying PoE do not show up in the management UI as powered. This means that the option to power cycle the attached device is missing.
Dear @Tescophil
Tescophil wrote
After this latest update some ports which are supplying PoE do not show up in the management UI as powered. This means that the option to power cycle the attached device is missing.
May I know how you manage this PoE switch, via Omada Controller? Or just in standalone mode?
We did test on Omada Controller but did not see the issue. If possible, could you please share us a screenshot of your management UI?
Hi @Hank21
I manage my devices with an OC200 controller which is connected directly to the switch in question.
When I went to check the status this morning I see that the PoE status for the particular port in question is now displayed correctly, as well as the PoE recovery button in the ports list.
Never seen this behavior before..., it happened after I power cycled the device in question using the PoE recovery button in the UI, and when it rebooted, the port on the switch status page was listed as connected, but showed now PoE status.
I'll grab a screenshot if it happens again...
Phil.
Helpful: 0
Views: 391
Replies: 2
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
