OMADA Update version 5.11.10 issues encountered
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.OMADA Update version 5.11.10 issues encountered
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
OMADA update 5.11.10 issues encountered:
Devices used: OC200 / ER605 / EAP110 3pcs
1. Voucher clients has no handover or roaming between EAP. Clients can not transfer between EAP.
2. In EAP, can not check how may clients & who is connected.
3. Wired and wireless connection is confusing.
4. Voucher clients need to delete & reconnect again after update.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi All,
A newer 5.12 Beta firmware has been released for trial, please follow the post link below for details.
Omada SDN Controller_V5.12.x (Updated on Aug 21st, 2023)
- Copy Link
- Report Inappropriate Content
Also with this update the web interface is slower then usual / with previous firmware
hiw can I rollback ?
- Copy Link
- Report Inappropriate Content
a bug has been discovered in 5.11 and it has been withdrawn, the recommendation is to install the old version until a new update is available
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Warning. the most important thing here is that you take a backup of controler before doing anything,
you must also have a backup of the controller before you upgraded, the new backup is not compatible with previous versions. (So old backup)
Now I no longer have the OC200 myself, but I can try following the memory :-)
What you must have before installation.
Backup of previous controler that match the version you are going to install
You must also have a site username and password for controler and sites.
the controller I think will be factory reset when you downgrade so everything will disappear.
1. Go to the products' home page and download the versions you want.
https://www.tp-link.com/en/support/download/oc200/#Firmware
2. Log in to the controller locally, there is an install software function. it is probably in the global setting somewhere.
3. install the old version.
4. configure the controller, run restore from earlyer backup and so on.
- Copy Link
- Report Inappropriate Content
Here is a how to upgrade. This show where to install software
https://www.tp-link.com/en/support/faq/3684/
- Copy Link
- Report Inappropriate Content
okay but I have make no backup before u installed the new firmware
so when I downgrade I lost all of my settings then ?
- Copy Link
- Report Inappropriate Content
Yep, then yo have to do it from scratch.
Mariomark1541 wrote
okay but I have make no backup before u installed the new firmware
so when I downgrade I lost all of my settings then ?
- Copy Link
- Report Inappropriate Content
My best tipp is alway do a backup when you have done a change with your controller, if not you can loos all one day. and you will before or later.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 2101
Replies: 17
Voters 0
No one has voted for it yet.