oc200 connected not blinking In light
help guys did your oc200 is blinking? it's connected and it's not blinking I just did update the firmware. is this normal?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @jhaime11
Thanks for posting in our business forum.
What do you mean? Be specific when you post here.
So the Link/Act should be blinking if the LAN is working. Traffic flows, Link/Act blinks.
The OC200 is not brick-able because we added the firmware recovery mode. If you are not using the official firmware and it bricks, there's nothing we can do to help or are obliged to help.
So, if you confirm that your OC200 is bricked, refer to this guide:
How to use the Recovery Mode to recover the firmware for Omada Hardware Controller
Unless there is a hardware issue with the OC200, then the hardware controller OC200/OC300 can be recovered. The recovery GUI can be accessed. If you don't access that, then please read the guide again and follow it step by step.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 454
Replies: 1
Voters 0
No one has voted for it yet.