Migration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Migration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Migration
Migration
2023-10-28 18:43:23 - last edited 2023-10-29 22:11:18
Hardware Version: V5
Firmware Version:

I am currently using the software controller v5.12.7. I have purchase a hardware OC200 and ran the latest update so now it's at 5.12.9.

Can I do a migration from Software v5.12.7 -> Hardware v5.12.9?

 

Thanks so much in advance.

  0      
  0      
#1
Options
1 Accepted Solution
Re:Migration-Solution
2023-10-28 20:19:01 - last edited 2023-10-29 22:11:18

  @darbuthnot 

 

Hey

 

If you backup the software controller and then restore it to the OC200 that will work for you.   I havent personally used the migration tool, but in theory it should also work

 

The only time ive known an issue is if the firmware you are moving too is older, in your case this isnt a concern.   The Hardware and Software controllers run the same SDN so as long as versions are good there should be no issues for you. 

Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:Migration-Solution
2023-10-28 20:19:01 - last edited 2023-10-29 22:11:18

  @darbuthnot 

 

Hey

 

If you backup the software controller and then restore it to the OC200 that will work for you.   I havent personally used the migration tool, but in theory it should also work

 

The only time ive known an issue is if the firmware you are moving too is older, in your case this isnt a concern.   The Hardware and Software controllers run the same SDN so as long as versions are good there should be no issues for you. 

Recommended Solution
  0  
  0  
#2
Options
Re:Migration
2023-10-29 22:11:36
Thanks so much....that worked perfectly!
  1  
  1  
#3
Options

Information

Helpful: 0

Views: 527

Replies: 2

Related Articles