Fixed IP not working
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi Guys,
I have a problem.
I cannot make omada fix IP for some of my clients. Whenever I click "Use fixed IP adress" nothing happens.
I tried to reset EAPs, Switch and OC200.
Tried to reconnect the clients - ip adresses are still assigned randomly
All my MAC assigned to IPs are visible @ DHCP reservation table
my net topology is:
Provider's router -> omada switch -> 3x EAPS with all clients.
all abovce devices are in the same subnet. 192.168.0.x
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Fix IP only works with Omada a controlled DHCP which is usually via the gateway. I'm not sure the 'Simplified' Omada model would allow you to leverage L3 capability in some of their switches to do this...doubt it.
In short, you want to fix IPs, you'll need to do that from the provider's router, or insert an Omada gateway between the ISP and your switch.
- Copy Link
- Report Inappropriate Content
Fix IP only works with Omada a controlled DHCP which is usually via the gateway. I'm not sure the 'Simplified' Omada model would allow you to leverage L3 capability in some of their switches to do this...doubt it.
In short, you want to fix IPs, you'll need to do that from the provider's router, or insert an Omada gateway between the ISP and your switch.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Buy yourself an ER605 and it will work as advertised.
For full functionality, your Omada must contain all elements in the stack, ie gateway->switch->AP. Some functionality is possible with a subset of those components, but not all. In your case, not having the gateway, means Omada controller has no ability to control what your 3rd party router is handing out. Not a defect, just reality.
- Copy Link
- Report Inappropriate Content
@d0ugmac1 ok nie I understand. Thank You
ER605 will work with omada controller?
- Copy Link
- Report Inappropriate Content
@VasquezPL yes, er605v2 is an entry-level gateway and is fully supported by latest controller versions.
- Copy Link
- Report Inappropriate Content
@d0ugmac1 thank you very much. I will order it today
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 653
Replies: 6
Voters 0
No one has voted for it yet.