TL-SG2210P and Cisco
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG2210P and Cisco
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
Hi,
I'm more of a server engineer rather than a network guru so please go easy on me ;-)
I'm trying to setup a little home lab. I currently have my core switch which is a Cisco 3750. The 3750 has various VLANs setup on it which trunk up to my Hyper V lab.
Ive purchased an 8 port TPLINK TL-SG2210P and need some advice on how to configure this to connect to the Cisco. Basically I want to plug devices (laptops, phones etc) into the TPLink and have access to the VLANs configured on in Hyper V (via the Cisco Trunks).
How would I go about doing this? Would I need to use LACP on the TPLink and Etherchannel on the Cisco? What about tagging/untagging/PVID etc?
Any advice would be greatly appreciated.
Hardware Version : Not Clear
Firmware Version :
ISP :
Hi,
I'm more of a server engineer rather than a network guru so please go easy on me ;-)
I'm trying to setup a little home lab. I currently have my core switch which is a Cisco 3750. The 3750 has various VLANs setup on it which trunk up to my Hyper V lab.
Ive purchased an 8 port TPLINK TL-SG2210P and need some advice on how to configure this to connect to the Cisco. Basically I want to plug devices (laptops, phones etc) into the TPLink and have access to the VLANs configured on in Hyper V (via the Cisco Trunks).
How would I go about doing this? Would I need to use LACP on the TPLink and Etherchannel on the Cisco? What about tagging/untagging/PVID etc?
Any advice would be greatly appreciated.
