@Choggins If all you need from Deco mesh is WiFi coverage, I would recommend to keep Hub in router mode and switch Deco mesh to AP mode. This is how I run Deco mesh at my house with my ISP cable...

@Jonathan85 Try powerline first. I would suggest the following approach: 1. Test to see if powerline link is stable and reasonably fast; 2. Use one of Deco M4 units you already have to see if setup...

@Sybren This may happen when you have mix of Deco units in your Deco mesh: some supporting Connection Preference feature and some not. For this feature to work, all Deco units must support it. If you...

@Panos13 Out of these two options I would prefer Alternative #2. Even if Deco mesh goes down, your wired equipment will keep working. Also, if you need to replace Deco mesh by some other brand of...

@pajtaz Ignore these and other errors messages in logs. If you want to see printer in Deco app, you will need to make changes in how it runs with static IP. Configure printer with dynamic IP settings...

@NaveenNL This is not about category. You have Ethernet cable which is obviously not up to declared specs. It happens. I have been using M5s with ancient Cat 5E cables (over 10 years old) but of good...