@DGB If you select the Deco you want to remove (from the show map / show list page), it will say CANT FIND THIS DECO or something like that.. top right corner is 3 dots.. in there choose REMOVE...

@Zhanat In the first SSID where you have WPA2/3 enabled, then the data between the AP and the devices on that specific SSID are encrypted using WPA2/3 algorithms. This will be secured via the passkey...

@Herbs21 Hey If you are going to run cables into the office / bedroom area and have the Deco positioned in there, then YES switch to Access Point mode. Honestly if you have reservations etc in place...

Hey If its gone blue then its into setup mode, this could simply be that its failed to update the firmware and has reset itself. Seen it just once or twice before, not common but does happen To fix...

@Damngflo In the controller just set the SSID for both frequencies, the controller will sort it. . It's generally accepted to use just set an SSID and the AP/controller will handle the frequency...

@Keetawat If you have not changed the default SSID, then it should be printed on the bottom or inside an attached card (in the box) Failing that if you connect to the AP via a cable and go to its IP...