@d0ugmac1 @.AT I don't have the same problem with my ER605 v1 leaking memory over time. Perhaps there is some feature or configuration you are using that has this problem and I am lucky enough not to...

@mhoam I noticed similar issue recently. After upgrading ER605 to 1.3.0, Firefox started being detected as not supported. Unfortunate decision for them to restrict to official Chrome/Edge only if...

@dpsguard I verified the number of sessions using the ER605's Session Monitor feature in standalone mode. This displayed a peak of just over 15k sessions. It was a very simple/crude testing method as...

@dpsguard I ran some stress testing on my ER605. Definitely not a direct comparison but something to think about. ER605 Starting RAM Usage: 33% Used (42/128MB) Start load/stress testing traffic with...

@Paulie1001 OC200 is good if you don't want to run it on a server (not ARM/PI compatible). OC300 is overkill and not necessary for your needs. Router options a) 1 x ER605 v2 - probably enough and...

@amscrey if the IP starts with 169.254 that usually means no DHCP server was available to provide an IP. You should also see that the default gateway is blank/missing. You could factory reset the...