Hi @jakslax Did you setup Access Control? You may try resetting the router and keep it in standalone default mode. Then run the speed test again. This test will prevent any influence from the...

Hi @JhonneL-MDA May I know which region you are located in? Different countries/regions use different firmware. Here is a link but note it may not suitable for your device.

Hi @Chad711 Fallback IP only takes effect when the EAP cannot receive IP from DHCP server. About 192.168.0.254, it's designed to be that IP by default. It's not coming from anywhere.

Hi @hanzS For tp-link switch, if you enable IPv4 routing on L3 interface configurations, then the switch will do the routing between VLANs, no need to add more static routing. Here is an example if...

Hi @AngelK To gather feedback from others, I'd like to transfer this thread to the block of "Requests & Suggestions" so that it could be seen by more people.

Hi @stevenb8 Maybe try a shorter Ethernet cable? (between the switch and your Wi-Fi bridge) When you connect a PC to the bridge receiving side, what IP address you can get? Make sure that is a...