@Virgo Thanks. Going to give it a try and will post back results.

Top part of image is current after entering orientation of APs into the Beta Map in Omada Controller.Bottom part is rotating the AP orientation which shows more of the signal penetrating into the...

@piaakit You could probably just use two EAP225.

@woozle Thanks for the response. I set the channel width to 80 and that did it.

Diagram shows current and planned setup. Currenly one EAP610-Outdoor Wired. Four EAP225-Outdoor. EAP225 #5 on the current side in linked the the EAP225 #4. #4 is linked to #1. The issue is the...

Maybe someone can advise me on this then? I am not familiar with the SFP Port. Is the uplink port or can any port on this switch be the uplink? If the SFP port has to be the uplink, I am assuming I...