@LudsuC To set up your Mercusys H50G mesh with ethernet backhaul, make sure the nodes are connected via Ethernet cables. In your current setup, it seems like the node is still connecting to the main...

@Westyy95 To factory reset your device, you typically need to access its settings. If you know your TP-Link password, try logging into the device's management interface. Once logged in, look for the...

@Aaksz Since your TP-Link extenders have received EasyMesh updates, you should be able to create an EasyMesh WiFi network between your TP-Link OneMesh extender and the new Mercusys MR50G AC1900...

@CasualUser Hi! Before buying the VIGI NVR1008H, I have a few concerns: Do cameras auto-connect to the NVR after a power failure? Does it have ANR like Hikvision for continuous recording? Have time...

@RSCW Hi there! To make the new 5-port switch utilize injector mode and recognize the POE++ injector, you may want to check the switch settings. Unfortunately, the SG2005P-PD might not have a direct...

@volfan In this case, the TL-SG108P won't be directly manageable from the OC200 controller, but you can connect devices to it and have them communicate through the VLANs set up on your managed...