@MR.S I think I figured out my configuration error. My firewall hasn't registred the DHCP entries in the dns server. So the name omada was not reachable. After setting this option the access point...

@MR.S Yes, the ports are open. Here a list from the host system, which ports are listening: The complete hardware construct where working on my home lab. I set everything up from scratch in my home...

@MR.S Thanks. The accesspoint is deleted already. And yes it is connected to the same network/vlan like the controller. From the controller I can ping the ap. But my reset actions where only <10...

@MR.S Yes it's enabled:

Hi, I've installed an Omada Controller via docker in a complete new network. I use the following hardware: 1 x SG3218XP-M2 v1.0 (1.0.2) 1 x SG3428XPP-M2 v1.20 (1.20.2) 2 x EAP673(EU) v1.0 (1.0.3)...

Thanks for this informations. After upgrade to firmware 1.2.0 the EAP Controller shows the right hw revision. R1D2 wrote So there is actually no difference on v2 devices with a new logo and v1...