I did an experiment today. I have the network with 3xBE25 and 3xX50/V1, all connected through ethernet / wired backhaul. I did the following steps: The Main Deco is a BE25 1) I removed wired backhaul...

@David-TP Based on the post by Mauriga, i did a reboot of my Deco system and I get exactly the same: the wify backhaul no longer works after a reboot. I unplugged ethernet from one X50 before reboot...

@David-TP It works again, but I had to reset all 6 Deco's I have and rebuild the network from scratch. Even then, "Replace Main Deco" did not work, but set new "Main Deco" worked after a new device...

@David-TP This is what I get when I try to change the Main Deco from an X50 to a BE25. I have upload the Deco APP Log.

@bobvana I know that neither the X50 nor the BE25 support easymesh and still I get a message that I need to disable easymesh as it is not supported and my WiFi backhaul on both X50 and BE25 is...

@MeOverHere Sopme further checking: The Deco app shows no device has easymesh active and I am not able to change to another X50 as Main Deco either.