GimeRasta wrote If anyone can help or know if its possbile. Can I access the EAP-225 Outdoor AP without it being connected to the internet. Sure, but you will need either a DHCP server in your...

peterholm1 wrote How do I adopt two EAP225 to a server based Omada-controller? When I use ubiquiti I use SSH to get in and adopt them with "set-inform"-command. If the APs are in the same subnet as...

Mitya wrote I am talking about management vlan only, not about packets from clients, you are right. I mean, you will definitely configure default route for switch to be able to have access from...

Mitya wrote T1500G-10PS and T1500G-10MPS had problems with gateway work, when you try to access your switch from different network. Sometimes it just stops to work and you can manage it only from the...

Polarice wrote Secondly, I guessed you would say go to the other devices. No, I asked why people request features on the grounds that »Cisco and UBNT has this feature, too« instead of buying Cisco or...

Resetting to factory defaults is always recommended when deploying a device with an unknown setup. Maybe the switch was configured to only allow mgmt access from a certain subnet. Anyway, great that...