Check that the subnet masks of both CPEs are the same. Are you really needing a /16 network? Next, try to ping the CPE#2 from CPE#1 and vice versa via built-in ping. If this works, the problem is in...

tx350z wrote I don't know how else to explain the problem; the built-in portals are tightly integrated into the controller software, bound to a single IP/port, and separated only by URI. That means...

The Arris is a router (they call it "gateway") with an additional modem. So if the DHCP pool gets exhausted by too many clients, use a bigger subnet. But DHCP leases not used for a while get recycled...

Pretty expensive and overkill for Fast Ethernet (you don't need CAT.6 or CAT.7, CAT.5e is more then enoguh). What's more, plugs on those cables are way too big for the limited space on CPEs. I use...

tacman7 wrote Now I'm going to spend more on a 50' cable than I did on the CPE510. But it says shielded and grounded. Good shielded cable with ground wire, 300m: 150 Euro. Connectors: 10 pieces 10...

homeIT wrote I looked through all the setting in the web UI and could not locate any evidence that these Easy Smart switches need or use time sync. Oops, yes, you're right. Did confuse this with...