The signal strength LEDs will turn on as soon as the wireless adapter is turned on. If set to factory defaults, the wireless adapter remains off until you changed the username/password of the web UI...

beboscky@yahoo.it wrote Thanks!Yes, config saved. The problem is that interface becomes invisible. It works. I need to reset it to re-acces it Can't reproduce this - my CPEs never did lose their...

beboscky@yahoo.it wrote I configured as a client with static IP but impossible to re-access to the interfice. to acces I have to reset it. firmaware version 2.1.1, but same problem with 2.1.6 Just to...

Roselawn wrote Also after I adjust the TCP/IP and then try to type in the address 192.168.0.254 all I get is an "cannot find address" page Very very very frustrating. What am I doing wrong? Did you...

The Riddle wrote Tried in client mode..Signal from AP2 is absurdly lower than in bridge( at BRIDGE survey)On my iPhone I get 2 Sec of connection and the “no internet connection”So nothing changed ......

Ok, I got it. You want to set up a WISP scenario. To do so, I would use client mode rather than bridge mode for the WA7210 in building C. Bridge mode will make all sorts of trouble such as bad...