Mqcarpenter wrote So is that a no? I already have the 1200. If I cannot use it to extend an existing signal, I will set up another wireless network on it for that side of the house through EAP. An...

darwin wrote It shows that each unit must be connected to the main router. Is this the case or can one unit be connected to the router and act as a centralized point to connect the other units...

marymayes1 wrote have a wbs510 trying to logon to ip address with windows 10 using chrome have updated chrome.i have been able to get on the setup page a couple of times but it lost connection. now...

You're welcome. To clarify the need for using 192.168.0.x subnet: It needs to be used just once for initial configuration of a CPE. In order to set a customized IP for the CPE you must use the CPE's...

ram-0000 wrote Do I miss something when reading the documentation ? You can set the IP in menu Network Setting → Switch IP Address. See page 41 of the User's Manual for TL-SG2216WEB.

Ecmml0207 wrote Now I see that I wish to connect two buildings, Should I use AP/Client mode or bridge? From a technical point of view there is not much difference between client mode and...