What does the command [CODE]ssh admin@ yourIP radartool numdetects[/CODE] print? Substitute yourIP with your CPE's IP address.

johnsnow wrote Although how is all devices getting the proper subnet with vlan3 set as untagged? You need to set up DHCP to provide IPs for each subnet. I'm not sure why you use VLANs at all if they...

If you use VLANs on an EAP, it must be connected to a trunk port. Is port 7 a trunk (tagged) port? There is too few information. How are ports 3 to 5 and 7 configured on the managed switch (VLAN...

There is no VLAN 0. Setting VID=0 disables the VLAN mechanism. In general, VLANs are meant to separate subnets at a switch and have this switch carry more than one subnet over the same physical...

Not that I know of. It does not log WIFi connects/disconnects.

I see. However, the CPE610 resembles the LBE-M5-23, not the LBE-5AC-23. It's like comparing the EAP225-Outdoor to a non-AC device from UBNT. Most often, the hard- and software of WiFi gear is made by...