With the current firmware you just assign a static IP outside your router DHCP pool (so no IP conflicts), reboot and that is it.

I pretty much believe this patch won't help, as this issue keeps happening even after changing subnet settings... however I found this somewhat useful as I can hide the AP from the VLAN, i give it a...

Yes, forward port were setup, in fact I could see (via ssh I could only look at settings, via telnet I could also set) all applied settings used by me to test. Other functions like LAGG, VLAN,...

Via telnet i was able to set it up, but the web interface remain unusable. Cheers

I tried to manage it using CLI via SSH, but: sw> enable sw# configure ----^ Error: Bad Command

Hi folks, I believe there is a bug in the port isolation web interface (Switching -> Port -> Port Isolation). I click on Edit, select the ports and Apply. On the Port Isolation List I see settings...