@djwujek I don't know why it won't start, there could be a lot of things causing problems but as you can see, Omada needs 1.2 GB of RAM to start and it increases gradually so until you solve the RAM...

@djwujek I did a test here on a 2GB Raspberry Pi4 with Raspberry Pi OS, once everything is installed it uses 1.2GB (but it will probably increase). If you create a larger swap file then you might be...

@djwujek It's not strange at all. You can run Omada on almost any hardware but you need to have 2gb I recommend 4gb as a minimum, the number of cores on the processor doesn't matter so much in small...

@Clive_A To downgrade the firmware, you need to log in to the router's console using SSH, then type these commands. enable (Turn on privileged commands) roll-back (Roll back to the previous software...

Clive_A wrote Hi @MR.S MR.S wrote @GRL It's SD-WAN that I've been looking forward to the most, so hopefully it will come to the other routers in beta soon. Too bad you had problems with your upgrade,...

djwujek wrote I know I wrote in the wrong section, I'm very sorry. I read the requirements but I need to adopt one router and a 5-port switch so I don't think the controller needs 4GB of RAM. Can...