@Zonelab goto site config, then general and remote logging.

@Tobias8250 You cannot change the default profile. you must create a new profile with the desired settings, then you must assign this profile to the switch port.

@MTHAREJA then I don't know, if the controller is on the same network as the access points, they should appear in the console. are you sure that the access points have not been adopted into another...

@Geert_V There is a solution but it is not very good, if you have an Omada switch you can do some LAN to LAN ACL on the switch. Omada is a network for the SMB market, I would almost say SOHO/SMB, so...

@MTHAREJA go to global view, then Controller Settings, make sure that Show Pending Devices is enabled.

@MTHAREJA Which hardware version and which firmware version do you have on the access points? And do you have access to AP web console in stand alone mode?