@fruv mesh doesn't use ssdi you create to mesh, mesh goes on a separate hidden ssid that you don't see. you don't need to create any ssid at all for mesh to work.

@Walt_White try and disable 802.11r on SSID also turn off 6Ghz The EAP650 connected to the TL-SG2210MP probably has a fault with the cable, check that it is connected correctly, it only supplies...

@fishermanG ok so all vlans work except vlan1, when I look between your config it's not so strange. remove 1 in vlan on your ppsk users. if it says 1 there it will not work on vlan1 on vlan1 you...

@Jeesoon1 No, not that I know of but if you disable auto failover, the ap will not mesh automatically. then you have to manually select mesh ap

@fishermanG yes, it seemed strange, I have a small lab with roughly the same setup as you, it has always worked, what happens there is a mystery, i have EAP653 but it is about the same as EAP650. as...

@fishermanG ok, then I have the whole picture I think :-) there is no reason why this should not work on EAP650 but works on ER706w have you configured anything else on the controller, switch/EAP acl...