@CS2 It must be something with the settings on the USB that has failed, it is probably a bit special to adopt a remote with USB, I don't know how the controller sends over the configuration to the...

@CS2 OK, did you set these settings before adopting? how is the setup on the site where the controller is? does it go via VPN or do you have NAT in to the controller?

@CS2 You probably have a huge problem. if you adopted without preconfiguring the USB interface, then everything is over on the WAN interface, which you have not connected to. can you send a...

@Tyrade I'm not sure, but I have something similar to the unifi access point and the switch port config is like that. interface GigabitEthernet1/0/8 description AcessPoint switchport trunk allowed...

@Tyrade do you define management vlan on access point? config and serice tab. if not, the access point still thinks it is on vlan1

@PNIY There is no fastroam between tp-link and unify ap. but I dont understand the IP releas after 5 minuttes, is there different IP nett? if you mix unifi and tp-link access point both should be on...