Hi, I've just installed this load balance router just for failover should my NBN connection (Australia) go down. I did testing an wan swapped to WAN2 when I turned of WAN1. All good. But during the...

@Kevin_Z Kev, I have done some more checking and found that the reason for not being able to ping the local devices, and therfore the deco not recognising the device as being on the network, is...

@Kevin_Z Hi Kev, I forgot the network and reconnected. Logged out and in again, but still no toggle. I noticed same on IPv4! So, I tired to ping 192.168.1.1, but no response. That's odd! Something I...

@Kevin_Z Hi Kev, Thanks for the reply. The Guest network is disabled. i don't use it. I have unplugged and disconnected all satellite decos (3). The only deco on is the M9 main router. Still cannot...

Hi, My Deco M9 doesn't allow me to toggle on the IPv6 switch. There is a message to say that IPv6 can only be configured when your device is connected to the Deco network. However, my device is...

@Kevin_Z Hi Kevin, my M9 is currently on 1.3.0 Build 20190821 Rel 54023 OK, I understand now - it see the new firmware on the link you gave above. You are right the Aussie site hasn't been updated...