@iresLeandro Hi, this is the 1.3.0 beta with WiFi heatmap. Did you run into any issues with this firmware? Best regards.

@Zmajur Hi, thank you very much for the feedback. May I know your Internet service provider? Do you subscribe to any TV/IPTV services from the ISP? The IGMP Proxy is usually enabled by default. (You...

@ddaggett4 Hi, I think it is probably due to too many Deco units in the Mesh network. You can find the IP address of each Deco BE11000 on the Deco App. If possible, you can pick one satellite Deco...

@ARGamingPK1 Hi, thank you very much for your time and patience. Is the satellite Deco connected via a network switch or a direct Ethernet cable? I think it is probably affected by other wired...

@Wobblyman Hi, thank you very much for the feedback. Here it is: the original 1.3.0 firmware for Early Access 1.3.0 26012212. Ref 11551 the new beta to fix the NAT Loopback issue on the above 1.3.0...

@Craxis16 Hi,welcome to the community. The 1.7.1 can downgrade to 1.5.5 via firmware recovery if needed: How to use firmware recovery if the Deco become brick I'll report the case to the senior...