@ARGamingPK1 Hi, it sounds reasonable, and I'll record it first. I think the "Beamforming" on Deco already helps to adjust the wireless transmit power based on the density of wireless device...

@Lunavia12 Hi, welcome to the community. Can I have your Deco model number? How about its current firmware version? It is recommended to refer to the following troubleshooting guide: Can't Access...

@pr1970 Hi, Thanks for the update. I notice the case has been escalated to the senior engineer for further assistance. Please check the email for more suggestions. Best regards.

@Dlanor Hi, Thanks for the update. If both band 1 and band 4 are allowed for 5 GHz, Deco would usually opt for band 1 as it is more widely used. If band 4 was selected, you might find that more 5G...

@HamHam Hi, if the IPV4 address is now the same as the public IP address from whatismyipaddress, there is no need to open any ports on Deco. What kinds of VPN servers have you set on the Deco? Have...

@Devotee101 Hi, thank you for the logs. I did receive your email. As the ISP gateway is also a router, do you set Deco X50 into Wireless router mode or Access point mode? If it is in wireless router...