@AX72 Archer AX72 supports only router mode and access point mode - here's the difference. To configure AX72 in AP mode you have to use a cable to connect it to your main router - details (Case 1)....

@_________ Double NAT is not necessarily a bad thing if you decide to combine a dedicated FW and a Homeshield router. It can complicate port-forwarding when a service in your LAN need it. I...

@TinyMarmot Is the Archer AXE75 your main router (is there any other routers in your network) ? Reboot the router and test again.

@Ruben007 AX53 supports Easymesh with an ethernet backhaul through a beta FW - check this thread. RE305 which is in AP mode can be replaced with RE315 which also supports Easymesh with an ethernet...

@stnigt You should look at HomeShield capable routers - details. The supported models are towards the bottom of the page. Here's a video presentation of this service.

@Scott_RE200 Here's a guide for configuring RE in AP mode. Some recommendations: If your main router LAN ip address is within the 192.168.0.0/24 subnet set a static IP for RE200 192.168.0.254 and set...