@Sino-Wu Use this guide to configure C6 in AP mode (Case 1). Thus you'll expand your wireless coverage. Archer C6 v4 and above will support EasyMesh, but you can name your C6 SSIDs the same as the...

@rhakbari This behavior has been observed before - here's an old thread on that matter. What you could try is to update your FW (Case 1) to the latest release - Archer C2300(EU)_V1_220114 and test if...

@johnwhelan Archer AX55 has an EasyMesh already implemented, but not through an ethernet backhaul. This feature is expected to be implemented as well, but I can't speculate about the timeline when...

@Thom_NL If you're using two C80 routers then you've built an EasyMesh network. Given that the two technologies are similar, my educated guess would be that the same limit for the nodes number is...

@Southware There's nothing special about configuring TL-WR841H in AP mode - use this guide for setting it up. You cable connection should be as follows: Mikrotik router LAN port => TL-WR841H Internet...

@Thom_NL Check this link - just before the Q&A section. " *Only one router is needed to build Mesh networks. OneMesh™ supports up to six OneMesh™ devices, including the router. "