Hi, I need help regarding setting up a LAG between two network switch. I have two switch and want to create a LAG using two ports. Switch 1 port 45,47 Switch 2 port 25,27 Should i use the passive or a

Hi, is there a way to configure the VPN IPSec Failover for Omada GUI ? https://www.tp-link.com/us/support/faq/3575/ this is for standalone mode and i cannot get to work with my setup. i have both site

After couple attempts at truly isolating my VLANs resulted in locking myself out of my network, I'm looking into giving it another shot. Troubleshooting such failures is limited to disabling deny rule

Hi, I would like to know if there is a settings to prevent access point in Omada from connecting via other AP as mesh. I have this setup. Room A with Switch A and Access Point A Room B with Switch B a

I have a multi VLAN network and i want to create a ACL to separate traffic, permit and deny the access of each vlans, and create a limited access. The basic lan network. name vlan subnet lan 1 192.168

I have two sites: Site "I" is the IPSec initiator. It is an ER7206 controlled through a local software controller. Locally it uses the 192.168.100.0/24 subnet. Site "R" is the IPSec Responder. It is a