Is there any way to set up Dynamic DNS so upon a failover to a backup WAN (not using load balancing), the Dynamic DNS will use the failover WAN's IP address to update the dynamic IP? It appears only p

I have connected two separate ISP providers to WAN2 and WAN3. My system status shows both as connected. I also configured the WAN ports for WAN2 and WAN3, disabling WAN1. However, when I go to the Loa

There is a -Lock to AP- *BUG* - Needs to be fixed ASAP. If you lock a device to an access point on the controller and then force a reconnection if the device cannot connect then when you click on the

Hi , i can replace this AP with eap225 outdoor ? now my eap 225 are configured on omada controller but there are power off for production .

I have been using TP managed switch, router, controller, and WAPs for the past 4 years. I initally used OpenVPN to connect and Windows RDP to connect to a computer. At some point, probably 18 months a

I have the following configuration as per the image, firmware as follows: ER605V2 - 2.2.6 Build 2024 20240718 Rel.82712 ES208G - 1.0.0 Build 20241121 Rel.81545 ES216G - 1.0.0 Build 20241128 Rel.71681