Hi, I have an issue with accesing Internet via WiFi connection. Setup: Controler: OC 200 -1.35.7 Build 20250514 Rel.51837 Router: ER605 v2.0 2.3.0 Build 20250428 Rel.18967 Switch: SG3428MP v6.20 6.20.

Hi everyone, I’m currently planning to upgrade my Omada router from the ER605 to the more powerful ER8411, and I was wondering if there’s any official protocol or best practice for performing this kin

I have following configuration for my office. Here, I have statically assigned address (192.168.0.0/16) for my clients below my cisco gateway. Controller gets 192.168.2.112, and ER605 gets 192.168.254

Hey there, I am facing a very hard time trying to get fixed IP adresses working. Nearly all my devices do not change their IP adress if I assign a static one. They will always get the one the initiall

Hello All, I have an OC200 Controller, i have adopted two devices (An AP EAP225-Outdoor and SG3452P), I have created Two SSID and i wanna create an captive portal for the users on the EAP225-Outdoor,

When I set a fixed IP sdress within the config page of a client, the settings will never change the current IP adress of the device. Even if I replug the ethernet cable and reboot the client, the same