5G/4G Routers
Hello, Our ISP (Free in France) provides IPv6 but they only talk about their own routers, not others. I upgraded ISP info (last version November 2025) but when I go to IPv6 tunnel, it still says there
InstallationIPv6
2Helpful
236Views
I purchased TL-MR100 router 2023. But unable to do the setup as I forgotten the local password. I have setup the SSID password successfully. I tried doing reset but still unable to setup the local pas
Installation
By
lookforsmt
· Latest post 2026-02-06 09:56:41
by David-TP
0Helpful
172Views
Hi There, Ive just recently gone from a BT Broudband router to a Archer NX500 at our commerical workshop. We can get the wifi and internet to work however the router isn't seeing the HIKVISION CCTV ha
Network ConnectivityInstallation
By
JamesCarter8632
· Latest post 2026-01-12 08:37:43
by David-TP
0Helpful
203Views
[Since there's only one place to put model, etc., here's the info for the Deco S4 Version 2.0 - don't know more than that as I haven't opened the box yet!] Ideally I’d like to turn the MR6400 into a m
InstallationDeco S4
3Helpful
268Views
Hi I have problem with Modem TL-MR6400 after update Firmware 1. There are Error Code : 1 2. Imei : undefined Is any solution to fix it...?
Network ConnectivityFirmware UpdateInstallationVoLTE
1Helpful
403Views
I have a Tapo C210 camera which won't connect to the internet. It connects to WiFi okay but have a consistent amber light meaning it can't establish a connection to the internet and device can only be
Network ConnectivityInstallation
2Helpful
255Views
Guys, I have a huge issue to connect my new bought (used) ne211 Outdoor to any GSM network. I tried 3 different sim operators (sims ok on phone). To antenna 300m. only power diode is lit, gsm diode no
Network ConnectivityInstallation
By
Jakobson2432
· Latest post 2025-08-04 09:55:52
by David-TP
0Helpful
872Views
Network ConnectivityFirmware UpdateInstallationAccess Point Mode
0Helpful
376Views
Network ConnectivityAccess Point ModeInstallation
1Helpful
626Views
Just swapped a VDSL Broadband router for a TL-MR6400 linked to Vodafone network. Openreach Internet useless around here so trying out LTE using the MR6400. I have two IP cameras on the network that du
Mobile Wi-FiAccess Point ModeInstallationNetwork Connectivity
0Helpful
333Views
Good morning, a technical question: if I do not use external antennas the signal strength is indicated at 75%. If I set the use of external antennas, whether they are installed as well as if they are
InstallationAntennas
By
Giovanni_Parma
· Latest post 2025-05-29 19:20:31
by Mike79
5Helpful
4458Views
I have installed an Archer NX200 together with a Poynting XPOL-2-5G roof antenna. In the router's admin interface I have enabled external antennas and selected Network Mode 5G/4G/3G. However, accordin
Network ConnectivityInstallationAntennas
1Helpful
1031Views