Feature Request (Deco)
2
VotesFeature request - please enable the option to set mtu sizes for each lan port when in access point mode (not router mode). It should be necessary to allow jumbo frame sizes for 2.5g, and especially fo
Access Point ModeMTU
45Views
0
VotesPlease bring "QOS" in Access Point mode on Deco X20 version 3.8 (IN). It will really helps us in controlling the amount of MAXIMUM data could be sent to one device. Sometimes downloading a 80gb Steam
Access Point ModeQOS
By
Decorer247
· Latest post 2024-10-16 08:41:34
by Sunshine
106Views
3
VotesThe 3 simple updates for the Deco XE75 Pro please. For Clarity: IPV6 when in AP mode - No IPV6 in AP mode currently is disgusting. It is 2024, IPV6 is used my most ISP's In device info for the Deco "u
IPv6Access Point ModeFeature Request (Deco)
By
Crazylife
· Latest post 2024-08-28 09:05:22
by toomuchnoise
237Views
2
VotesI've gotten a Deco M4 from my ISP with my subscription as a bonus. This AP caused me to blow through a DNS server rate limit resulting in my account being disabled, permanently. I managed to finally f
Access Point ModeDNS
By
decom4victim
· Latest post 2024-06-14 07:50:17
by decom4victim
236Views
4
VotesHi, I wish to ask the following: can you add remote syslog feature? I wish to track WIFI clients (mac address) connected to my mesh network. Regards, Hristo
Access Point Mode
227Views
3
VotesI am planning to set up a mesh system in my home using the Deco E4 but I am stuck with a problem. I have an ISP's router in the middle of my house, right next to it I plan to set up a deco unit as my
Access Point Mode
242Views
2
VotesHi All , I have few questions about the Guest Network configuration: Q - Is the guest network isolated from the other networks? Q - Is is possible to force guest SSID users to accept terms and to time
Access Point ModeParental Control
By
IanAlmighty
· Latest post 2024-02-18 12:00:36
by David-TP
607Views
2
VotesI've recently purchased and installed a Firewalla Firewall, which allows me to create network segementations for better security. I've installed it as my router, leaving by Deco X55 in AP mode. I can
Access Point ModeNetwork Segmentation
By
RealShinka
218Views
1
VotesI was wondering if I could make a feature request so that I can specify which port is used as the WAN port, rather then replying on the auto sensing functionailty. As I had an issue recently where my
Access Point ModeLAN
372Views
2
VotesWould be nice to have the option to filter out the use of VDSL frequencies on the powerline side of things as I've been reading other power line adapters support this and there can be interference bet
Access Point Modevdsl filter
624Views