Deco
When using the Deco XE75 Pro in AP Mode there is no option to enable IPV6. This seems crazy. No reason exists for not having IPV6, as far as I can see. Is there something that I am missing? The app se
Access Point ModeFirmware UpdateIPv6Deco Lab
0Helpful
266Views
I had 2 E4 decos earlier where there used to be a toggle button shown in front of the connected devices to Enable/Disbale Mesh for that device. I added a Deco X20 as my Main Deco and connected the E4'
Network ConnectivityDeco LabMesh toggle
By
praticgupta
· Latest post 2024-08-02 09:53:33
by praticgupta
1Helpful
185Views
My home network has five TP-Link Deco: three of them are M5 while the other two are M4. The M4 are V2. FIrmware version is the latest for any Deco. All of them are connected through ethernet cable. On
Deco Ethernet BackhaulDeco Lab
By
Tadiern_80
· Latest post 2024-07-29 07:12:03
by Tadiern_80
3Helpful
453Views
The convenience of setting up the a local wifi mesh with the Deco App is unparalleled to what I have seen elsewhere. What surprises med is that I cannot seem to find a point to point bridge in the sam
Outdoor Wi-FiInstallationDeco LabDeco App Related
0Helpful
107Views
I am using IPV6 based internet but DECO X95 does not support it. How do I open IPV6 settings.
Deco LabIPv6
1Helpful
195Views
Hi, I have Deco X95 and the main Mesh and I would like to add as a slave X50 4g or X20 4g with a backup Sim It is possible that the main Deco will be my strong Mesh X95 and the X50 will be just a fall
Network ConnectivityDeco Lab6 GHz
0Helpful
83Views
Recently, I purchased a Deco M4 (v2) router in Malaysia. However, I live in Bangladesh, where mobile devices typically support band 4. Because of this, I cannot use the 5GHz band on the router, which
Firmware UpdateDeco Lab5GHz
1Helpful
172Views
I'm planning out Smart Home and I was planning to have Kasa switches with Tapo Sockets both with Matter support. My prefference would be to connect everything to Deco X50 - PoE, but currently it doesn
Feature RequestDeco LabMatter
1Helpful
201Views
I encountered an issue with high ping using the Deco X50(1.2) system. It is running the latest firmware and is set up in Access Point mode. For devices experiencing the issue, I have disabled mesh con
Network ConnectivityAccess Point ModeDeco LabIssue
3Helpful
488Views
Same problem as this thread: https://community.tp-link.com/en/home/forum/topic/606638 Basically, I go to NAT forwarding, Port Forwarding, + and then when I enter for example: Service type- Custom or H
Port ForwardingDeco Lab
0Helpful
191Views