Deco
I resently aquired two BE65 routers, as wifi upgrade was due. Along with this i have upgrade my Wifi on the Intel NUC8i7HVB to a Intel BE1750X Killler. The killer app that comes along with the Wifo NI
Wi-Fi 7
3Helpful
138Views
Hello, I'm going to buy 2 packs of 2 xe75 decos (4 units) to install in a single-story house, my question is whether this model has ethernet backhaul, whether the first deco can be connected to the ro
By
Decoxe75pt
· Latest post 2 weeks ago
by Alexandre.
0Helpful
69Views
This might sound like a stupid question but I'm not tech savvy enough to know this! I have a dual band gigabit wifi 6 router, and to improve my speeds and coverage around the house, I have just bought
By
Maddogg69
· Latest post 2 weeks ago
by Alexandre.
1Helpful
94Views
Hello! I have encountered a problem with my Deco M4 devices. My network looks like this: I would like each Deco device to connect straight by cable to the router. Unfortunately, even after changing th
Network ConnectivityAccess Point ModeDeco Ethernet Backhaul
3Helpful
231Views
Hi i have TP-LINK Deco X50 5G I'm from Iran i couldn't connect to internet when I upgrade to last version of this deco 1.0.2 build20230411. i need help to downgrade to firmware Deco X50-5G(EU)_V1_1.0.
Firmware UpdateReports
0Helpful
136Views
Hi. I recently purchased a 3-pack of Deco S7 v1.0 and configured it in Wi-Fi Router mode to replace my previous router, aiming for a seamless mesh network experience at home. However, I've noticed tha
Firmware UpdateFeature RequestInstallation
18Helpful
417Views
Hello, I recently got phone notification from Deco app about data usage report and I could see traffic usage stats. It looked like this: And now I can't get to the same view of report. Can you help on
By
allex742
· Latest post 2 weeks ago
by NabillPakhri
1Helpful
295Views
I'm trying to set up a three pack M4 Deco to my Talktalk fttp ont but the primary unit is staying red and won't connect. I've followed the instructions on the app, Dynamic IP etc but still red. The M4
Network Connectivity
By
charliebob70
· Latest post 2 weeks ago
by charliebob70
1Helpful
75Views
I just replaced my old Archer C20(V1) to a Deco M4(V2) but I still have a dead zone in a room. I was wondering if I could still use the C20 to work via WDS connecting to the M4 mesh network. I've trie
Network Connectivity
2Helpful
67Views
Hi, I have a network set up with the X55 working properly. Main deco connected to the FTTH router (5e cable) and satellite deco to the main deco via ethernet backhaul. The satellite deco supports more
Network Connectivity
0Helpful
80Views