TP-Link TL-WR902AC in Client mode not connecting to Ruckus SZ100 R500 APs
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-Link TL-WR902AC in Client mode not connecting to Ruckus SZ100 R500 APs
Model :
Hardware Version :
Firmware Version :
ISP :
Hi,
we want to use a TP-Link TL-WR902AC Wireless Travel Router setup in Client-Mode connecting to our Ruckus WiFi Infrastruktur (SZ100 with R500 APs) getting a wired Copy-Device wireless.
I can scan the Wifi-Networks on the TP-Link client and the networks are available, but it is not connecting. There are also no entries in SZ100 Log shown where any connection attempt of the client are made
SZ100: 3.5.1.0.862
AP Firmware: 3.5.1.0.490
TP-Link TL-WR902AC: 3.16.9 Build 20170628 Rel.37804n
Any hints, or other people who tried a similiar setup?
Regards
Peter
Hardware Version :
Firmware Version :
ISP :
Hi,
we want to use a TP-Link TL-WR902AC Wireless Travel Router setup in Client-Mode connecting to our Ruckus WiFi Infrastruktur (SZ100 with R500 APs) getting a wired Copy-Device wireless.
I can scan the Wifi-Networks on the TP-Link client and the networks are available, but it is not connecting. There are also no entries in SZ100 Log shown where any connection attempt of the client are made
SZ100: 3.5.1.0.862
AP Firmware: 3.5.1.0.490
TP-Link TL-WR902AC: 3.16.9 Build 20170628 Rel.37804n
Any hints, or other people who tried a similiar setup?
Regards
Peter