Archer MR200 - Can't VPN!
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer MR200 - Can't VPN!
Model :
Hardware Version :
Firmware Version :
ISP :
Last week I bought a pair of MR200 V2 because I need to setup a VPN between 2 locations.
I installed the SIM cards everything is working fine, connected to the Internet via 4G, downloaded the latest firmware directly from the router upgrade page and firmware now is : 1.3.0 0.9.1 v004a.0 Build 180117 Rel.47657n
Since my Internet connections aren't static, I setup two ddns.net accounts one for each and they're both working fine and connected to the ddns service.
I then proceeded to setup the VPN by reading the instructions on the manual and I believe that I did it correctly. Below are the screen shots from both units (Local is the bigger one and Remote the smaller)
The VPN doesn't connect no matter what I tried!
Am I missing something or done anything wrong?
Regards,
Ted
Hardware Version :
Firmware Version :
ISP :
Last week I bought a pair of MR200 V2 because I need to setup a VPN between 2 locations.
I installed the SIM cards everything is working fine, connected to the Internet via 4G, downloaded the latest firmware directly from the router upgrade page and firmware now is : 1.3.0 0.9.1 v004a.0 Build 180117 Rel.47657n
Since my Internet connections aren't static, I setup two ddns.net accounts one for each and they're both working fine and connected to the ddns service.
I then proceeded to setup the VPN by reading the instructions on the manual and I believe that I did it correctly. Below are the screen shots from both units (Local is the bigger one and Remote the smaller)
The VPN doesn't connect no matter what I tried!
Am I missing something or done anything wrong?
Regards,
Ted