Archer MR200: Failover not working
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer MR200: Failover not working
Model :
Hardware Version :
Firmware Version :
ISP :
Hello,
I have a MR200 router and I would like it to change to 4G if my WAN goes offline.
Therefore I set it to wireless router mode and installed it after the router I got from my provider. So the MR200 get's the ip address from the provider's router. So I have the following setup:
WAN <-> provider's router <-> MR200 <-> LAN
Then I activated the 4G backup option.
1) When I pull the LAN cable out of the MR200, the router changes automatically to 4G. Perfect!
2) When I disconnect the provider's router from WAN, nothing happens. There is no internet connection at all, but on the admin page the router tells me that it is still connected. I expected that the MR200 would change to 4G, but it doesn't.
Is there anybody here who uses the 4G backup function?
Hardware Version :
Firmware Version :
ISP :
Hello,
I have a MR200 router and I would like it to change to 4G if my WAN goes offline.
Therefore I set it to wireless router mode and installed it after the router I got from my provider. So the MR200 get's the ip address from the provider's router. So I have the following setup:
WAN <-> provider's router <-> MR200 <-> LAN
Then I activated the 4G backup option.
1) When I pull the LAN cable out of the MR200, the router changes automatically to 4G. Perfect!
2) When I disconnect the provider's router from WAN, nothing happens. There is no internet connection at all, but on the admin page the router tells me that it is still connected. I expected that the MR200 would change to 4G, but it doesn't.
Is there anybody here who uses the 4G backup function?
