TP Link MR400 (or MR200) : DHCP Option 60?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP Link MR400 (or MR200) : DHCP Option 60?
Model :
Hardware Version :
Firmware Version :
ISP :
Hi,
Is it possible to set the DHCP option 60 (aka VCI dor "vendor class identifier") on the interface of these routers? It is required to replace my ISP router by mine.
Looking in the GUI emulator found in the TP-Link website, I found a 'Vendor Id' setting in Lan Settings \ Condition Pool, but I'm not sure it is DHCP option 60. Can someone confirm (or infirm) me it is?
Thanks in advance,
Hardware Version :
Firmware Version :
ISP :
Hi,
Is it possible to set the DHCP option 60 (aka VCI dor "vendor class identifier") on the interface of these routers? It is required to replace my ISP router by mine.
Looking in the GUI emulator found in the TP-Link website, I found a 'Vendor Id' setting in Lan Settings \ Condition Pool, but I'm not sure it is DHCP option 60. Can someone confirm (or infirm) me it is?
Thanks in advance,