how to know if deco are connected with ethernet backhaul
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
how to know if deco are connected with ethernet backhaul
HI;
I was under the impression that with this latest firware update I can know if a unit is ethernet or wifi conencted to the main deco.
can I tell this in the app? I couldnt find the way
thanks.,
Re:how to know if deco are connected with ethernet backhaul
Open Deco app, click the slave Deco and then you can see the signal source, it will indicates how does it connect to the main Deco to get internet.
You can refer to the picture attached below.
Nice to Meet You in Our TP-Link Community.
Check Out the Latest Posts:
Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN
Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router
EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller.
Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul
If you found a post or response helpful, please click Helpful (arrow pointing upward icon).
If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
