Deco M5 custom dns

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M5 custom dns

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M5 custom dns

Mikkelmaan

2019-08-09 11:32:42 - last edited 2019-08-09 11:34:14

Posts: 3

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2019-01-29

Deco M5 custom dns

2019-08-09 11:32:42 - last edited 2019-08-09 11:34:14

Model: Deco M5

Hardware Version:

Firmware Version:

Hi all

Some time ago, I had my custom DNS (Pihole) set up via the DHCP DNS settings, but after an update at some point, my wifi started acting up - as I remember my phone lingered on a specific station even though I was in the other end of the house. I disabled the custom DNS and all went back to normal.

Fast forward to the other day where I tried to add the custom DNS again but this time in the IPv4 settings described here: https://www.tp-link.com/us/support/faq/1855/. I didnt go well as the router crashed and suddenly assigned a new IP range to my network (192.168.1.* -> 172.16.0.*).

Which way is the correct way to enable a custom DNS and is it supported in 1.3.1 build 20190617 rel. 47476?

\Mikkel

1 Reply

Kevin_Z

2019-08-12 09:45:26

Posts: 21750

Helpful: 5135

Solutions: 2565

Stories: 21

Registered: 2018-12-24

Re:Deco M5 custom dns

2019-08-12 09:45:26

@Mikkelmaan

What is the current network diagram?

In general, if the WAN DNS or WAN IP is in the same network segment as the LAN IP, it will cause the IP conflict.

So it is recommended to change the WAN DNS and make it not in the same network segment as the LAN IP.

Click here to change WAN DNS:https://www.tp-link.com/support/faq/1855/

Good day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Deco M5 custom dns

Deco M5 custom dns

Information

Voters 0

Tags