cant acces utility window
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
cant acces utility window
Region : Others
Model : TL-WR740N
Hardware Version : Not Clear
Firmware Version :
ISP :
I seted up router and i coud acces the utility window, then i switced from w7x32 to w7x64 and then i try to acces the utility window i can only see
Username or Password is incorrect.
Please refer to the troubleshooting below:
Is the "Caps Lock" enabled on your keyboard?
The username and password must be lowercase, please ensure that the "Caps Lock" LED is disabled on your keyboard and try again.
Forgot your username or password?
Please reset the device to the factory default settings if you have forgotten your username or password. The default username and password are both set as "admin".
Note: The settings will be restored to factory default after the resetting.
How to restore the device to the factory default settings?
Firstly locate the reset button on the rear panel of the unit, whilst the device is powered on press and hold the reset button for more than 5 seconds, the device will then reboot and restore itself to the factory default settings.
no pop up window appears i tried looking this up and the closest thing i found was to uncheck the proxy but its not checked so what shoud i do to be able to acces utility window?
Model : TL-WR740N
Hardware Version : Not Clear
Firmware Version :
ISP :
I seted up router and i coud acces the utility window, then i switced from w7x32 to w7x64 and then i try to acces the utility window i can only see
Username or Password is incorrect.
Please refer to the troubleshooting below:
Is the "Caps Lock" enabled on your keyboard?
The username and password must be lowercase, please ensure that the "Caps Lock" LED is disabled on your keyboard and try again.
Forgot your username or password?
Please reset the device to the factory default settings if you have forgotten your username or password. The default username and password are both set as "admin".
Note: The settings will be restored to factory default after the resetting.
How to restore the device to the factory default settings?
Firstly locate the reset button on the rear panel of the unit, whilst the device is powered on press and hold the reset button for more than 5 seconds, the device will then reboot and restore itself to the factory default settings.
no pop up window appears i tried looking this up and the closest thing i found was to uncheck the proxy but its not checked so what shoud i do to be able to acces utility window?