Deco M9 and virgin hub3 WiFi speeds
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi totally new to this mesh thing. I set up my deco M9 x 3 connected via cable to virgin hub3 (on 350mbps contract). Switched hub3 to modem mode and all working but now I’m only getting 75mbps wireless on all 3 decos. Hub was delivering 300 in the room where it is situated. Have I done something wrong? Why would the speed have dropped off so much in a room where I was previously getting a great speed? I’m in an old house with thick walls
and wondered if I should be switching hub3 back to router mode?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
What is the current network topology/layout?
With your device connected to the Deco wifi network, please check the wireless link speed as the instruction below:
https://www.tp-link.com/support/faq/2265/
Please connect your computer to the main deco and test the speed you can get from it by ethernet cable and check the wired link speed as well.
Note: Please show us a screenshot of the speed test result.
Try to run a speed test on the Deco app and show us the test result.
Have a great day.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@tgo I found a similar thing. M9s work beautifully with SuperHub in router mode and just plugging into one of the ports. Putting the hub into modem mode screwed things up, so have just turned off the virgin wifi.
I guess the question I am left with is: is there any great disadvantage to this set up?...
- Copy Link
- Report Inappropriate Content
I've been running just fine for the last month or so with just the Deco Wi-Fi active, I just felt it stopped any confusion/congestion and to be honest the Virgin Wi-Fi signal is so crap that it was the reason I got the Deco to start with... I don't suppose it would hurt to have both running, I just liked the neatness of having the one (Deco Wi-Fi) running.
Although because of Chromecast/steaming issues, I did get a small 4 port switch and made sure I plugged everythnig wired into that (with the switch connected to the Deco ethernet port) so in effect ALL devices were running on the Deco rather than just wireless stuff and wired on Virgin as it caused issues with having some devices on the VM network and others on the Deco so for me. EVERYTHING goes through the Deco only.
- Copy Link
- Report Inappropriate Content
@tgo Yes that was my feeling. Everything I have read says trying to hook up the M9 with the superhub as a modem is a nightmare. A friend of mine works for AWS and straight out said don't bother with that. The only challenge i now have is IP addresses: the Deco issues them in a different range to the superhub. I experimented with turning off the DHCP on the superhub (my mate thought that might work) but the Deco complained profusely. So resorting to inserting a switch to ensure everything fed by the Deco, whether ethernet or wifi.
- Copy Link
- Report Inappropriate Content
@Mcdryburn I have exactly the same setup. Many people across the UK must have this setup. Somebody from TP-Link could give us the best solution. Virgin say contact TP-Link, so much for customer service.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 4049
Replies: 6
Voters 0
No one has voted for it yet.